Contact us
MORE+Hydraulic shear

Product maintenance
1. Daily checkpoints
Whether there is any damage or deformation of the body, whether there is leakage of the hose connection,pin and bushing damage check and its replacement cycle, check the loosening state of bolts and nuts, check the oil level and loosening of the gear and tighten the loosening bolt.
2. Regular checkpoints
The seals and rotating parts of the hydraulic cylinder will wear out, and should be replaced in time after reaching the service life. Replacement parts should be matched with the original factory.
3. Check the tightening state of bolts and install new bolts. Check and ensure that the bolts tightened are not loose after 8 hours of use. The damaged bolts should be replaced in time. Bolts should be replaced after approximately 1500 hours or 12 months of use after installation.
4, in the process of use, it is recommended to check regularly whether there is oil leakage to ensure no fault, so as not to affect the normal use.
Every 4 hours : add lubricating oil, lubrication shaft pin and rotating gear 1 time.